Installation Process of Kingly Finishes
For Exterior Applications
Measure the surface you plan to cover
1
2
The surface to be treated should be thoroughly clean and dry
Mix the Adhesive Part A with the Adhesive
Part B in a ratio of 1 to 1 until a homogeneous mixture is obtained
3
4
Apply the Adhesive mixture to the desired surface
5
Spread the Adhesive mixture with a notched trowel
Place the Kingly Sheet on the chosen surface
6
7
Roll over the entire surface, making sure to apply pressure throughout the area
8
Wait 24 hours until the adhesive dries completely
9
Sand the corners with sand paper
10
Protect the corners of the Kingly sheet with masking tape
11
Apply the grout in the joints
12
Remove the tape and apply the Kingly Sealer on the entire surface
13
Let the Kingly Sealer dry for 24 hours
Your project is done!
Installation Process of Kingly Finishes
For Interior Applications
Measure the surface you plan to cover
1
2
The surface to be treated should be thoroughly clean and dry
Using a caulking gun, apply the adhesive around the perimeter of the Kingly sheet leaving an offset of ¾” width
3
4
Apply the adhesive leaving spaces of approximately 1¼” between each adhesive strip
5
Place the Kingly sheet on the chosen surface
press firmly from the center to the edges
6
7
Roll over the entire surface, making sure to apply pressure throughout the area
8
Wait 24 hours until the adhesive dries completely
9
Sand the corners with sand paper
10
Protect the corners of the Kingly sheet with masking tape
11
Apply the grout in the joints
12
Remove the tape and apply the Kingly Sealer on the entire surface
13
Let the Kingly Sealer dry for 24 hours
Your project is done!
KinglySlate, a new way to use stone
KinglySlate, a new way to use stone
Properties
Installation process for interior applications
